- This topic has 1 reply, 2 voices, and was last updated 16 years, 6 months ago by
.
-
Posts
-
been here today old lady complaining of when put on spin it doesnt.i put it on spin and pump runs but no motor action i cancelled it off checked motor and module connections tried again and it span,i cancelled machine again and tried again and it didnt.Question is are these pcbs iff and has anybody had this before?is there a test procedure for this model.
cheers chris
Re: hoover hnwl7166
It could be the selector switch playing up. Had a few of these not catching the right programme.
I can’t remember but is the drain programme next to the spin only programme? If you see where i’m coming from?
The test programme is the same as all the nextra machines. Its in the fault book.
Turn dial two clicks clockwise whilst holding start…. blah blah blah.
I always get an error 13 on the washer dryers but its a phantom error as the dryer is fine!!!!
Hope this helps.
- You must be logged in to reply to this topic.