beko dishwasher

Re: beko dishwasher

usually pcb tbh, im sure they end up stuck on the prewash cycle or something, changing pcb has cured a fair few for me, be careful tho there can be a few different part numbers for the pcbs.

Re: beko dishwasher

This may help you.

Functional test
In order to enter the functional test mode (short program mode), select the knop position of 2 while the DW is out of energy (on/off
is shut) then press the start button and energize the DW and keep pressing on the button for 3 seconds.
All of the indicators turns on for 2 seconds after entering the short program mode.
Program following indicators blink if there exist any fault.
After entering the short program mode, press “start” button and begin for the short program. Short program follows the steps below.
1. Draining (15 seconds)
2. Water inlet (4.4 lt)
3. Water circulation , regeneration (60 sn),
4. Detergent (60 sn), heating (to 65° C) .
5. After reaching 65° , stops heating and water circulation. The water inside is discharged for 30 seconds. Waits for
pressing the start button.
Short program mode will be finished
In the case of any fault formation, the fault is shown by the program following indicators. Showing is as below:
All program follow indicators are off No fault
Washing indicator is on Water inlet or water counter is faulty
End indicator is on NTC is faulty
Both indicators are on Heater is faulty
All of the indicators blink after the functional test finishes in the case of no fault occurred