hOTPOINT TDC60s tumble dryer

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hOTPOINT TDC60s tumble dryer

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • September 30, 2009 at 9:49 pm #48981
    mike412
    Participant

    Hi Folks.

    This dryer cuts out after it has been on 2-3 mins, both neons on front go out.

    Press start button and it will run for a further 2-3 mins. Is the start relay part of the dryness module on this dryer or is there a relay hiding somewhere?.

    Thanks in anticipation,

    Mike.

    October 1, 2009 at 10:32 am #298395
    iadom
    Moderator

    Re: hOTPOINT TDC60s tumble dryer

    No relay fitted, not come across this on a TDC60 would only be a guess as to module fault, does it keep on running if you hold the start button in or press hard on the door?

    October 1, 2009 at 10:49 am #298396
    LJDomestics
    Participant

    Re: hOTPOINT TDC60s tumble dryer

    Were is the sensor unit located on this model?
    Are all the connections tight on the module?

    October 2, 2009 at 7:26 pm #298397
    mike412
    Participant

    Re: HOTPOINT TDC60s tumble dryer

    Thanks for the replies guys.

    Customer threw this one at me as an extra when I was looking at Bosch washing machine. Got to go back during the week with part for that so will take a closer look at the dryer then. Anyone got any bedtime reading?

    Thanks once again,

    Mike.

    October 2, 2009 at 9:20 pm #298398
    iadom
    Moderator

    Re: hOTPOINT TDC60s tumble dryer

    What happens if you set it to timed drying?

    If set to module controlled drying without clothes in it will stop but not after 2 or 3 minutes.

    Also worth checking the braided copper brush is touching the drum.

    PS. Check your inbox.

    Jim.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.