Replacing built in oven and hob – gap required?

Home › Forums › Public Support Forums › Help And Support › Cooker And Oven Forum › Replacing built in oven and hob – gap required?

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • October 7, 2009 at 5:24 am #49143
    speedygonzalez
    Participant

    I’m planning on replacing my old built in oven and hob with a new one. However Comet say that a 2cm gap is required between the oven and the kitchen units/ worktop all the way round. My present one doesn’t have this gap. Is this correct?

    October 7, 2009 at 7:56 am #298863
    don
    Moderator

    Re: Replacing built in oven and hob – gap required?

    Hi

    There is always a sufficient air gap around all built in ovens. Oven widths are 54cm while the carcass width will be 56cm. You will also get sufficient gap along the top as well. If in doubt just check the installation instructions that come with each oven.

    HTH 🙂

    Don

    October 7, 2009 at 8:42 am #298864
    speedygonzalez
    Participant

    Re: Replacing built in oven and hob – gap required?

    Thanks Don. The slot I have for the oven is 60cm by 60cm so would this Beko be okay?
    http://www.beko.co.uk/ProductDetails-22 … 22300.aspx

    October 7, 2009 at 10:26 am #298865
    don
    Moderator

    Re: Replacing built in oven and hob – gap required?

    According to the link the furniture apperture required is HxWxD mm 595 x 560 x 550, so yes it will fit.

    HTH 🙂

    Don

    October 7, 2009 at 10:39 am #298866
    speedygonzalez
    Participant

    Re: Replacing built in oven and hob – gap required?

    Brilliant 😀 Thanks Don.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.