- This topic has 2 replies, 3 voices, and was last updated 16 years, 6 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
Got power into the machine and out of the suppressor but everything else is dead. Suspect either the timer or module at fault. Anyone got any ideas.
Re: Hoover/Candy CMD146-80
Had one where the pump was open circuit.
But generally the module is at fault.
Re: Hoover/Candy CMD146-80
Probably main PCB. 😥
Look for:-
1) Green corrosion on the selector unit connections caused by poor lid sealing – can blow the PCB;
2) Water traces on the pump (blows the board);
3) Ribbon cables chafing on the motor mounts; shorting out to earth and blowing the PCB.Lovely machines these Candy offerings………. 👿 EMW repair and reprogram these boards. Some new ones are supplied non – configured, so watch out for that. 😉
Hope that helps,
Steve.
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.