Zanussi E10

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi E10

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 8, 2009 at 9:22 pm #49191
    washermanuk
    Participant

    Help please if possible? A Zanussi ZJD1219 (914601904/04) Built in washer dryer, fault is E10 Filling problem? 😕
    Work done so far with two visits : Cleaned dryer ducting below fan which was blocked with fluff,
    then found heater on dryer down to earth and replaced. Checked condensor valve and removed square plastic cap to see if i had a trickle of water and all seems okay?
    Now it works fine on the washing cycle and dryer is okay with one dry load but when used again on dryer cycle the error code E10 appears!!!
    Any ideas chaps? STAT maybe?

    October 8, 2009 at 9:31 pm #299050
    leavemetogetonwithit
    Participant

    Re: Zanussi E10

    Common fault. Green coloured solenoid coil (drier) works for 10 mins then goes o/c as it warms up. Replace; all will be well.
    Mike.

    October 8, 2009 at 9:33 pm #299051
    helo_75
    Participant

    spot on, but id change the pump as well

    October 8, 2009 at 9:36 pm #299052
    washermanuk
    Participant

    Re: Zanussi E10

    Thanks guys 😀
    would give you all a big sloppy kiss xxxxx ( manly one’s) 😉
    Thanks for the quick replies

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.