- This topic has 1 reply, 2 voices, and was last updated 16 years, 5 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
this originaly had a faulty main board (burnt on pcb machine dead no lights) ordered one from emw and fitted ok i then found the facia board was locked up fitted one i had in stock i can now switch the machine on and off and select programmes however the programmes are all mixed up i have since spotted that the blue inlet coil has melted and is now o c i am now going back tommorow to fit another coil and change the pressure switch to see if it cures the problem any advice on this would be appreciated thanks cras
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.