bosch wfo2865gb/08

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › bosch wfo2865gb/08

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • October 17, 2009 at 10:37 am #49388
    OLLIE2806
    Participant

    Hi guys,
    How do i go about and how hard is it to change the inner drum on one of these its a plastic tub? I’ve Never done one before.
    Thanks
    Paul

    October 17, 2009 at 10:58 pm #299731
    leavemetogetonwithit
    Participant

    Re: bosch wfo2865gb/08

    You might find this thread of use.
    bosch+bearings
    Mike.

    October 18, 2009 at 4:58 pm #299732
    OLLIE2806
    Participant

    Re: bosch wfo2865gb/08

    Thanks mike

    October 18, 2009 at 6:43 pm #299733
    nomadPaul
    Participant

    Hi Ollie , its not too bad a job….time consuming more than anything.
    Can i ask why you’ve got to change the inner drum ? I can’t remember ever having to change one on its own so would be interested in your fault .

    Paul

    October 19, 2009 at 7:18 pm #299734
    OLLIE2806
    Participant

    Re: bosch wfo2865gb/08

    a couple of the little holes in the drum are knackered – Very mis-shaped snagged and dented, they are pretruding, therefore catching everything put in the wash, I’ve tried poking them back down, it is better but its not good by any means

    October 19, 2009 at 7:49 pm #299735
    nomadPaul
    Participant

    ok mate. Only had one similar to that and it was a drill bit that got trapped between the tubs and bent the hole out as you’ve described. I was lucky and managed to ‘tap’ it flat with a hammer 🙂

    October 21, 2009 at 7:08 am #299736
    OLLIE2806
    Participant

    Re: bosch wfo2865gb/08

    Done! (What a bloody job that is. lol) As you said previously – not too bad really just time consuming, Thanks for the advice guys.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.