Accessing Miele Diagnostic mode w2444wps

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Accessing Miele Diagnostic mode w2444wps

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • October 19, 2009 at 4:43 pm #49433
    gandh1
    Participant

    W2444WPS
    flashing inlet failure led
    flashing drain failure led

    Customer has already checked drain and it will empy, couldnt tell me if it was any slower than normal tho, and checked water was ok by slackening water feed… causing wetness 😕

    Havent looked at it yet, possible blocked sump, or aquastop failure??

    Also, no error codes flashing up so may well need to access diagnosics on it. any help to do this would be appreciated as Ive found hte miele fault code list!

    Cheers

    Rich

    October 19, 2009 at 4:58 pm #299892
    russell555
    Participant

    Re: Accessing Miele Diagnostic mode w2444wps

    flooded base….. probably either a torn door seal or a leaking pump…..
    get the front cabinet open and it will be obvious where it is situated

    October 19, 2009 at 6:26 pm #299893
    washermanuk
    Participant

    Re: Accessing Miele Diagnostic mode w2444wps

    If both are flashing it will be water protection!!!
    I find its normally when customer empties filter some of it runs inside machine and causes the float to activate
    hope this helps
    Brian

    October 19, 2009 at 7:01 pm #299894
    gandh1
    Participant

    Re: Accessing Miele Diagnostic mode w2444wps

    ok cheers for that guys, dont normally take on miele but good customer of ours so need to look after her 😀

    October 19, 2009 at 7:15 pm #299895
    Seamy
    Participant

    Re: Accessing Miele Diagnostic mode w2444wps

    Tilt up the machine back wards slowly & this should allow the water to run out, otherwise its off with the front & sponge with basin job..

    October 21, 2009 at 3:14 pm #299896
    gandh1
    Participant

    Re: Accessing Miele Diagnostic mode w2444wps

    money in the sump 😀

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.