AEG Lock clicks not starting

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › AEG Lock clicks not starting

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • October 20, 2009 at 4:41 pm #49473
    pmb
    Participant

    AEG L50815. 91452401401
    Interlock keeps clicking, Then ends programme
    Replaced interlock still the same,
    Machine is only 2 years old.
    Any ideas

    October 20, 2009 at 7:08 pm #300009
    suedehead1
    Participant

    Re: AEG Lock clicks not starting

    i had the same fault the motor brushes had worn down too far and shorted the pcb.

    October 20, 2009 at 7:17 pm #300010
    pmb
    Participant

    Re: AEG Lock clicks not starting

    I checked the brushes, one of them anyway, hardly any wear
    PCB are £133+vat So i dont wont to order one unless i am 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure.

    October 20, 2009 at 7:18 pm #300011
    suedehead1
    Participant

    Re: AEG Lock clicks not starting

    did you check the pcb for blown tracks?

    October 20, 2009 at 7:25 pm #300012
    Simon46
    Participant

    Re: AEG Lock clicks not starting

    I was caught out by this! Put insulated driver push lock manually to engage. If machine starts pin in door catch has slipped down. must be out by micron as it looked ok.

    S.

    October 21, 2009 at 7:30 am #300013
    pmb
    Participant

    Re: AEG Lock clicks not starting

    Replaced interlock and operated manually,
    No i didnt check for blown tracks, should have, but if its the PCB,
    I will not do the job (out of stock anyway) and tell customer to ring AEG

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.