Hoover TC650

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hoover TC650

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • October 20, 2009 at 7:16 pm #49484
    aqua_serve
    Participant

    Guys,

    Do any of you have the manual for this tumble drier???

    I’m trying to replace the heater unit on it but getting into the back of the machine seems to be a mission in itself.

    Ans usual I appreciate your help,

    Mark

    mark_r_ryan@hotmail.com

    October 20, 2009 at 7:29 pm #300035
    Alanj
    Participant

    Re: Hoover TC650

    Hi Mark, should just be a back cover comes off and you gain access to heater. Connectors for heater inside back panel.

    Alan

    October 20, 2009 at 7:44 pm #300036
    deltra
    Participant

    Re: Hoover TC650

    i once cut an access panel into the back of one of these(angle grinder 😈 ) just to change the heater ❗

    October 20, 2009 at 7:51 pm #300037
    helo_75
    Participant

    except its a condenser, and the fans in the way

    good quality connectors are what i use, cut and butt, unless you want to take off the lid, front off, baffle and drum out.. just to get to the conecting plugs?

    thought not

    October 20, 2009 at 8:14 pm #300038
    timdowning
    Participant

    Re: Hoover TC650

    I’ve mentioned it a few times that you can pop inwards the ty-wrap at the back and pull the connectors through the grommet area. You can with a fiddle pop the stud of the ty-wrap back in as well. Silicone up the grommet and jobs a good-en.

    October 21, 2009 at 10:56 am #300039
    wilf
    Participant

    Re: Hoover TC650

    the easy way to refit the clip is to thread a piece of 1mm 7 strand through the hole hook one strand round the clip and pull gently then cut off the wire

    wilf

    October 21, 2009 at 8:58 pm #300040
    aqua_serve
    Participant

    Re: Hoover TC650

    Cheers for all the help guys.

    Unfortunately one of the connectors popped off when I was trying to hook it out. Looks like I might have to use a hole saw to carefully cut a small hole in the back of the unit. It can’t possibly be worth stripping the machine just to get to it 🙁

    Mark

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.