- This topic has 1 reply, 2 voices, and was last updated 16 years, 5 months ago by
.
-
Posts
-
Went to this one having been told that the (qualified electrician) bruv had diagnosed the faulty circuit board but had been unable to locate a new one. It had all been left disconnected and he’s now hundreds of miles away. Anyway, I could see it was the interlock triac blown so i took it home and soldered on a new triac plus two adjacent resistors which were also o/c.
Went back today and only remembered about the wiring when I got there. Connected it up as best seemed fit but when switched on it was dead.
I think it might be the two red/green wires which go to the connector beside the selector sw.”X10″ I put the insulated one on pin 2(left) and non-insulated on pin 1(right). Also the far left connector with two black wires I put on “X2” which I’m not 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure about. A wiring diagram would be much appreciated.
Mike.
- You must be logged in to reply to this topic.