Bosch Exxcel 1400

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #49808
    mollysman
    Participant

    Hi all hope someone can help me. I had a problem with my washer not compleating the wash ie the last fast spin the timer would go from 8 mins to 1 and then 0. I replaced the brushes and cleaned the motor checked presure switch which seemed ok put all back together and it worked fine for about a month now its doing the same thing again. Ive checked all the orange wires from logic board to motor and they seem ok machine works and does everything even spin mid cycle before rinses its just the last spin any help would be wellcome
    Machine No is WFO2865GB/1
    Could this be the logic board
    Thanks
    Dave

    #302385
    gandh1
    Participant

    Re: Bosch Exxcel 1400

    sometimes need to bare the replacement carbons edges down slightly with a bit of wetndry otherwise they stick in the cartridge if theres any nicks in them. i would have thought if it was anythign else it wouldnthave worked for a month…

    #302386
    mollysman
    Participant

    Re: Bosch Exxcel 1400

    Thanks for reply already eased the brushes so they slide freely in holders
    there as been a strange smell sence replaceing them but thought this may be some sort of protection on the carbon ive since cleaned them with spirit but smell still there. motor runs really smooth and quiet when washing cycle but just wont reach speed on spin and then stops.
    Dave

    #302387
    mollysman
    Participant

    Re: Bosch Exxcel 1400

    For anyone with the same fault i.e not spining and jumping from 11 mins to 1 min it was the motor on mine so if the machine is in good condition which mine was its worth doing. £158 deliverd a lot less than £500+ for a good new one hope this helps someone

    Dave

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.