- This topic has 3 replies, 3 voices, and was last updated 16 years, 5 months ago by
.
-
Posts
-
Hi All Been to this today. Fault reported was not washing as it should.
The machine did not seem to take much water in when I first switched it on.
I checked all hoses around the chamber on the side and the fill hose to the sump of the machine, all are as new. Is it possible for the main fill hose on this model to cause a problem. It has a very expensive looking fill hose with a plastic box just after the tap. When the machine has filled and starts to wash if you open the door you can just see the water in the base around the filter.
Thanks, RayThe plastic box just after the tap is an aquastop. Its a safety device and has nothing to do with fill levels.
I’d be looking at the pressure chamber on the left hand side . This is what controls the water level. When full , the water should just reach the salt pot lid .
Are you sure the waters not backing up into the pressure chamber causing the appliance to low fill ? If it does , the blue arm on the pressure chamber will operate early , and the wash motor starts to early.Re: Bosch Shv43a03gb
Hi Thanks for that. No I am not sure its not backing up. Do the pressure chambers need cleaning or just replacing.
Ray.
- You must be logged in to reply to this topic.