AEG WM,not starting

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › AEG WM,not starting

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • November 9, 2009 at 4:19 pm #50005
    pmb
    Participant

    AEG LW1259 91400245100.
    Customer ordered Door gasket over phone,
    Fitted gasket, tryed to start, “end” light comes on, but wont start
    It was no problem before they say and i believe them.
    I didnt have exact interlock but a different shape zannussi one,
    plug fits and numbers the same. but still the same.
    Have ordered interlock but not confidant its that.
    Ideas

    November 9, 2009 at 11:34 pm #303011
    leavemetogetonwithit
    Participant

    Re: AEG WM,not starting

    Follow wires back up from door sw to check plug didn’t get pulled off of module during exertions of fitting new seal.
    Mike.

    November 10, 2009 at 12:33 pm #303012
    pmb
    Participant

    Re: AEG WM,not starting

    I had told her to try it the next day and she just rang to say its OK.
    It was the gremlins again.

    November 10, 2009 at 12:57 pm #303013
    gandh1
    Participant

    Re: AEG WM,not starting

    maybe she slams the door and us repairers are too gentle and didnt engage?

    November 10, 2009 at 10:36 pm #303014
    leavemetogetonwithit
    Participant

    Re: AEG WM,not starting

    I’d take a good look at the interlock to check for any signs of heating (the slightest hint of yellow near where the ptc is). Can cause expensive damage to board if not caught early.
    Mike.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.