- This topic has 4 replies, 3 voices, and was last updated 16 years, 5 months ago by
.
-
Posts
-
i have got the same prob as pasted below but i have changed the front and side module, please help as dont know what to check next
Bosch t dryer WTE6920 GB/01
you can set all controls start light flashes
push start buton light stops flashing
dry light illuminates and thats it total silence no fault codes and no movement or heater
time counts down on the auto settings timer will stop after so long proving sensors are active
i am assuming main pcb will be at fault part no 26 7937 but at £132 plus not the sort of part you want to get wrong
not sure if emw can do these boards may only be a relay
Re: bosch t dryer WTE6920 GB/01 DEAD SILENCE!!!! HELP
if it is a relay you can check yourself but you have to operate the pcb with accees to relay coil terms if you get a voltage at coil and relay does not close you have found it
have just done this on a bosch dryer that is not heating relay had 9v on coil but not operating have just got new relay will fit tomorrow and find out only stand to lose £4 if i am wrong not a bad gambleDave
Re: bosch t dryer WTE6920 GB/01 DEAD SILENCE!!!! HELP
Hi, thanks for the quick reply, i should have mentioned that i have changed the module, so that rules out relay probs etc…. so back to square one 🙁
Re: bosch t dryer WTE6920 GB/01 DEAD SILENCE!!!! HELP
sound like a weird fault
was it the same with the original boards
take it you have checked heater etc for continuity in case board does checks before it starts
Dave
- You must be logged in to reply to this topic.