creda bearings

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › creda bearings

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • November 12, 2009 at 2:38 pm #50100
    fasetester
    Participant

    hi guys have to look at a creda1000 washing machine. that is making a noise probley bearings gone. is their much involved in changing the bearings on this machine. if the shaft is damaged would you have to fit a spider complete with bearings or are the not worth fixing.thanks fasetester.

    November 12, 2009 at 4:01 pm #303492
    robbra
    Participant

    Re: creda bearings

    Nice machines and well worth doing but spider and bearings needed, wouldn’t do without a spider. About 1h 15 and pretty easy. I charge £85 and check brushes too.
    Rob

    November 12, 2009 at 5:38 pm #303493
    iadom
    Moderator

    Re: creda bearings

    Thats assuming it is a Hotpoint WM based machine. There are some 1000 spin Creda machines that are not WM based.

    What is the model number Fase?

    November 12, 2009 at 6:41 pm #303494
    fasetester
    Participant

    Re: creda bearings

    not sure guys the only number that the could see was17110 does the front split on these thanks fasetester

    November 12, 2009 at 6:48 pm #303495
    iadom
    Moderator

    Re: creda bearings

    You will be fine with that one, as robbra says, very straightforward.

    It is based on a Hotpoint 95/WM series machine. I’m sure you will have done those already.

    November 16, 2009 at 12:46 pm #303496
    fasetester
    Participant

    Re: creda bearings

    thanks guys for your reply when checked out it was the bearings in the motor . can you still get the armature and the bearing as a kit. thanks fasetester. 🙂

    November 16, 2009 at 3:34 pm #303497
    robbra
    Participant

    Re: creda bearings

    Should be able to get it from Qualtex but not sure of the part no. Had 2 on the van for about 2 years and used them both 2 weeks ago 😀
    Rob

    November 16, 2009 at 4:25 pm #303498
    iadom
    Moderator

    Re: creda bearings

    I always carry a couple, still use one or two every month. ARM20. 🙂

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.