HOTPOINT FDW80

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › HOTPOINT FDW80

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • November 12, 2009 at 3:00 pm #50101
    talkingtent
    Participant

    Anyone help? Went to this dishwasher, motor was siezed solid replaced with new motor. Now near the end of cycle fault AL05 shows up ? I know AL05 is circulating motor but why would i have this fault with a new motor fitted? Doesn’t do it every time. Any ideas

    November 12, 2009 at 3:11 pm #303499
    Martin
    Participant

    Re: HOTPOINT FDW80

    There are two different motors for this model and I’m not sure if they are interchangeable? If the correct motor was fitted then does it spin freely once connected to the pump impellor? If tight it may be drawing too much current hence the AL05 error maybe?

    November 12, 2009 at 3:19 pm #303500
    talkingtent
    Participant

    Re: HOTPOINT FDW80

    The motor fitted looks exactly the same as the one taken out. Motor runs free not tight. Any other suggestions?

    November 12, 2009 at 5:42 pm #303501
    iadom
    Moderator

    Re: HOTPOINT FDW80

    As Martin says, two different motors that are not interchangable.

    If you can give us the full serial number and the part number of the motor you fitted we could check it out for you.

    November 12, 2009 at 5:52 pm #303502
    talkingtent
    Participant

    Re: HOTPOINT FDW80

    I can tell you part number was C00115902 will let you know the serial number tomorrow.

    November 12, 2009 at 6:53 pm #303503
    iadom
    Moderator

    Re: HOTPOINT FDW80

    That motor is for serial numbers up to 60621.0000

    For serial number after 60621.0001 the motor is a C00145642.

    Jim.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.