smeg dishwasher dwi409c

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › smeg dishwasher dwi409c

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • November 12, 2009 at 10:51 pm #50113
    suedehead1
    Participant

    its a slimline dishwaher it had water in the base i dried it out but it fills up again slowly its not coming from the motor but i cant see where it is coming from any ideas welcome thanks.

    November 12, 2009 at 11:06 pm #303572
    eastlmark
    Moderator

    Re: smeg dishwasher dwi409c

    favorite leak points are the upper spray arm tube at the rear just behind the circ pump or the screws around the filter being loose. other than that its usually the circ pump or the 2 o rings in the right hand (as you look at the front) side panel where the air break meets the water softner, not such a common leak point on these as it is on the 60cm ones though. You can remove the base with the machine in situ and watch for drips.

    November 13, 2009 at 7:43 pm #303573
    suedehead1
    Participant

    Re: smeg dishwasher dwi409c

    thanks very much i will give that a try.

    November 15, 2009 at 6:12 pm #303574
    suedehead1
    Participant

    Re: smeg dishwasher dwi409c

    the grey plastic nut which holds the salt container in place was cracked and this is where the leak is.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.