Zanussi ZSF4123 module mishap

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi ZSF4123 module mishap

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • November 18, 2009 at 7:44 pm #50251
    Johnnyboy
    Participant

    Zsf 4123 slimline 91161501301
    while changing over a blown module (heater realy fault) a connector “fell apart” while changing it over, 2 orange wires. The one next to the green connector that is to be changed. Now when it is switched on there are no lights, did I connect the orange wires the wrong way round? or is the module faulty, I tried putting the blown module back in but it too had no lights (gulp). any hints
    cheers guys
    Johnnyboy

    November 18, 2009 at 8:02 pm #304114
    geoff1
    Participant

    Re: Zanussi ZSF4123 module mishap

    Hi

    I think that the power plug (Live/neutral) may be in the wrong way round.

    If you send me you email address I will send you some stuff

    Geoff

    November 20, 2009 at 2:50 pm #304115
    Johnnyboy
    Participant

    Re: Zanussi ZSF4123 module mishap

    the green connector was not replaced as it was over the serial number, Is thet the connector you mentioned?

    November 20, 2009 at 5:45 pm #304116
    geoff1
    Participant

    Re: Zanussi ZSF4123 module mishap

    Hi

    you have mail. Information about plug reversal is on page 34

    Geoff

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.