- This topic has 5 replies, 4 voices, and was last updated 16 years, 4 months ago by
.
-
Posts
-
Where is the flow meter in this D/W eng couldn’t find it, does it have impeller type.
Towards end of program fills for 5 secs then MTs for 5 secs continuouslyModel S4443W7/GB/01 FD8309
Re: Neff d/w Flow meter?
Dont think this model has a flow meter, think it has a float inside the sump.
There are some Bosch with a flow meter similar to the Diplomat type, located at the LHS rear beside the inlet valve and they do fail.
But as I said I dont think your DW has it.
Brian
Re: Neff d/w Flow meter?
No flow meter on this one its got mushroom thingy in the base . Sticky float ?
Re: Neff d/w Flow meter?
Thanks Scots & Pinky
What does this look like? is it inside cabinet or underneath,
Thanks again Kirk
Kirk , the level on this is controlled by a float in the sump. As you look down into the sump , there is a small circular cover at about the 5 o’clock position. Pop this cover off to revel the float in its channel. You may find this float is all gunged up and isn’t rising as the water fills the tub. Hence you get an overfill condition and a constant fill/drain cycle.
Take out the float – making a note of its orientation , and give it a good clean. Also clean the float channel with some hot water so that the float travels freely up and down without stickng.
Hopefully this should clear your fault
- You must be logged in to reply to this topic.