Hotpoint WMT01 wash speed problem.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WMT01 wash speed problem.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • November 22, 2009 at 7:39 pm #50344
    aqualectric
    Participant

    Hotpoint WMT01 washer.

    Machine fills, washes fine, heats up to the temperature set; then the drum speed increases to distribute speed for a couple of minutes. It does this and then returns to normal speed. The wash water is whipped into a froth and this fills the drum with suds. 😕 I’ve tried the electrical connections and swapped the motor. (original one had an insulation fault.) Otherwise everything works normally..
    The problem still exists – any ideas??

    Steve.

    November 22, 2009 at 8:09 pm #304502
    Penguin45
    Participant

    Re: Hotpoint WMT01 wash speed problem.

    I think you’ll find it’s behaving to specification, Steve.

    Chris.

    November 22, 2009 at 8:19 pm #304503
    helo_75
    Participant

    deplastering?

    enzyme plateau?

    quite normal, as chris says

    November 22, 2009 at 8:40 pm #304504
    aqualectric
    Participant

    helo_75 wrote:deplastering? enzyme plateau?

    Uhh?? I’ll have an ounce of whatever Helo is smoking! :snigger:

    OK, so it’s fine then. After building 4 machines today, a fault was the last thing I needed to see…….. 8)

    Thanks guys,

    Steve.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.