- This topic has 4 replies, 5 voices, and was last updated 16 years, 4 months ago by
.
-
Posts
-
ZWD1662W Prod 914603211
When you select any programme on this machine the programme time comes up on display and the start pause button flashes but when you press start the door doesnt lock and nothing happens. Fitted new interlock, selected programme (spin) pressed start, door locked and machine started to pump out, after about 5-10 seconds it stopped. Door then unlocked and now its doing the same again, door wont lock and machine wont start. Control board looks ok on inspection. Didnt have another interlock to try.Any ideas?
Subs
Re: Zanussi Interlock?
Possibly worn carbons……or PCB if the original interlock has shorted…. 🙁
Steve.
Re: Zanussi Interlock?
When Simon says “low” insulation on dryer element he doesn’t mean 1 megohm. 20M will be low enough. Just disconnect the element anyway and see what happens. And if it’s in a damp place check for condensation on motor brush holders which will also stop machine starting.
Mike.Re: Zanussi Interlock?
subs wrote:ZWD1662W Prod 914603211
When you select any programme on this machine the programme time comes up on display and the start pause button flashes but when you press start the door doesnt lock and nothing happens. Fitted new interlock, selected programme (spin) pressed start, door locked and machine started to pump out, after about 5-10 seconds it stopped. Door then unlocked and now its doing the same again, door wont lock and machine wont start. Control board looks ok on inspection. Didnt have another interlock to try.Any ideas?
Subs
had one doing same change pcb now working fine
- You must be logged in to reply to this topic.