- This topic has 2 replies, 2 voices, and was last updated 16 years, 4 months ago by
.
-
Posts
-
Hi all, first time i have come across one of these new design dishwashers.
It will start with the drain pump, then a short burst of circ pump followed by a longer run of drain pump and another short burst of circ pump – then E24 error shows on the display.
I realise that the error code is indicating a drainage problem, but it seems to be pumping fine, and is empty.
I cannot find a pressure switch cannot see how it is registered when empty- unless (guessing) the short runs of the circ pump is to monitor motor load current, to indicate pumping water – or empty (less current)?.
Any advise much appreciated.
MartinFirst off , i’d check in the sump and the little grey (?) cover that sits over the pump impellor. If this has come loose or been knocked out of position , the appliance may drain , albeit over a longer time , but as the pump pressure is low , it see’s it as a no-drain state. I’ve had 2 like this in the past 3 months
- You must be logged in to reply to this topic.