Miele G6381 Dishwasher

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Miele G6381 Dishwasher

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • December 4, 2009 at 9:06 pm #50691
    mike100
    Participant

    After 5 to 10 mins running water / inlet light starts flashing.
    Pump ok , no water in base
    Did reset heater stat underneath, and it ran for about 3 months ok.
    Now same again, stat ok.
    I’m thinking heater el has gone but struggling to get this one out to get to test it. It looks bent.
    Would like to return with part if anyone thinks it is likely to be heater then can do job in one go.
    Any suggestions please.
    Mike

    December 5, 2009 at 4:28 pm #305657
    philfish
    Participant

    Re: Miele G6381 Dishwasher

    have you checked flow meter sometimes they can stick and it don’t register properly

    phil

    December 9, 2009 at 4:59 pm #305658
    mike100
    Participant

    Re: Miele G6381 Dishwasher

    Thanks Phil,
    Sorry been away so not replied before

    Where is flow meter on the miele. Does it look like the impeller jug on the Bosch d/w?

    Mike

    December 9, 2009 at 9:13 pm #305659
    Seamy
    Participant

    Re: Miele G6381 Dishwasher

    Flow meter is little circuit board located on fill chamber, side of machine.
    Blockage inn circulation pump can cause similar problems if it doesn’t achieve or keep pressure up.

    December 10, 2009 at 8:38 am #305660
    mike100
    Participant

    Re: Miele G6381 Dishwasher

    Thanks guys,
    Let you know.
    Mike

    December 13, 2009 at 8:50 am #305661
    mike100
    Participant

    Re: Miele G6381 Dishwasher

    Turns out to be blockage in circ. pump impeller.

    Thanks for all your advice

    Mike

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.