Whirlpool AWZ7913 Condenser Drier

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Whirlpool AWZ7913 Condenser Drier

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • December 7, 2009 at 11:47 am #50727
    Auldyn
    Participant

    I have one of thiese in the workshop heater is OK runs but will only supply heater with power for 10 secs on any cycle not heat related i.e NTC because it will still only supply powerfor 10 secs with the heater disconected,
    you can also hear the relay click off on the main control board after 10 seconds.

    any ideas?

    December 7, 2009 at 2:29 pm #305754
    A1TEC
    Participant

    Re: Whirlpool AWZ7913 Condenser Drier

    Heater stat’s 3 of them built in to the heater, one is some sort of safety overheat stat. Only available as complete unit around £70.00 😯

    John.

    December 7, 2009 at 4:13 pm #305755
    Auldyn
    Participant

    Re: Whirlpool AWZ7913 Condenser Drier

    power cuts after 10 sec even when heater is detached the two thermostats are in the heater circuit, NTC sensor is attached via another plug and is seperate tried another NTC and it still does the same.
    main control board looks ok and connectors fit firmly.
    does not appear to be a heater or stat problem.

    December 7, 2009 at 6:41 pm #305756
    SparkyP
    Participant

    Re: Whirlpool AWZ7913 Condenser Drier

    Auldyn

    I will send a pm…….

    December 7, 2009 at 6:59 pm #305757
    Auldyn
    Participant

    Re: Whirlpool AWZ7913 Condenser Drier

    Thanks SparkyP
    It has 2 blue wires to heater and 2 white wires to NTC sounds like a write off if it needs a new heater and control board.
    Thanks for your help

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.