help-bosch fault – UK Whitegoods

This topic has 7 replies, 6 voices, and was last updated 16 years, 4 months ago by abbots.

Viewing 8 posts - 1 through 8 (of 8 total)

Author

Posts
December 7, 2009 at 6:05 pm #50737

abbots
Participant

hi,

WFX3267GB

customer complained that machine not spinning.
carbons were completely gone, so replaced.
machine now spins and pumps a treat but when it gets down to 1 minute on the display it goes back upto 47 minutes and carries on.
no fault codes are displayed.
any help really would be good.
cheers.
john

December 7, 2009 at 6:15 pm #305790

nomadPaul
Participant

Is this on a wash cycle ? I’d check that the heater isn’t open circuit or going down to earth.

December 7, 2009 at 6:22 pm #305791

abbots
Participant

Re: help-bosch fault

wash/rinse or spin the customer says it happens whatever program it is.
john

December 7, 2009 at 6:58 pm #305792

lee8
Participant

Re: help-bosch fault

Possible PCB issue.

December 7, 2009 at 8:16 pm #305793

Redflame
Participant

Re: help-bosch fault

You could also check the pressure system is completely clear & not scaled up. 😛

December 8, 2009 at 8:51 am #305794

Martin
Participant

Re: help-bosch fault

abbots wrote:wash/rinse or spin the customer says it happens whatever program it is.
john

That confirms it then, I’m with nomadPaul on this one. Whip your Megger out. 😉

December 8, 2009 at 3:15 pm #305795

subs
Participant

Re: help-bosch fault

I had a similar problem to this after replacing brushes on a bosch. Went back took out motor and completly cleaned out all the carbon dust, which sorted the problem.

Subs

December 8, 2009 at 5:27 pm #305796

abbots
Participant

Re: help-bosch fault

cheers,
already tried that, and used a com. stick on the armature.
jk
Author

Posts

Viewing 8 posts - 1 through 8 (of 8 total)

You must be logged in to reply to this topic.