Whirlpool Fault code, “CLEAN PUMP”, any ideas

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Whirlpool Fault code, “CLEAN PUMP”, any ideas

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • December 10, 2009 at 7:12 pm #50860
    Troffy
    Participant

    got this one yesterday, clean pump light was flashing so cleaned pump started machine and everything was fine, customer rang today to say the same lights flashing but when she presses the start button again the machine goes right through the cycle, anyone know whats causing this, any help would be good on this one

    cheers Ian

    December 10, 2009 at 7:54 pm #306183
    jackster
    Participant

    Re: Whirlpool Fault code, “CLEAN PUMP”, any ideas

    It could be that a coin is lodged in the drain hose causing it to block intermitantley or a common one is for socks etc jammed in the sump hose.
    Also crud in the pressure pot?

    December 10, 2009 at 8:21 pm #306184
    Troffy
    Participant

    Re: Whirlpool Fault code, “CLEAN PUMP”, any ideas

    i stripped all the drain hoses out and they were all clear, the pump was working fine too, there was a lot of grot around the eco ball but i cleaned all that too, got me stumped

    December 12, 2009 at 6:58 pm #306185
    SparkyP
    Participant

    Re: Whirlpool Fault code, “CLEAN PUMP”, any ideas

    Hi Troffy

    Take the eco ball out……….If the customer does low temp washes the eco ball sticks and then times out after 6 mins.

    HTH
    Sparkyp

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.