Bosch Classixx Condensor Fault

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch Classixx Condensor Fault

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • December 14, 2009 at 10:43 am #50935
    cooky
    Participant

    I have a Bosch Classix condensor dryer, E-nr no. WTE84107GB/01.
    On sensor or timed drying it will only run for a few seconds, then stops and the filter light starts flashing along with the start/stop light.
    It does the same thing with or without a load in it. The heater is ok as is the rear stat.
    Any ideas? Thanks

    December 14, 2009 at 2:57 pm #306388
    lee8
    Participant

    Re: Bosch Classixx Condensor Fault

    Check all fans are intact, also check the condensor and filter are clear.

    Enter test program and function test or record last known fault.

    December 14, 2009 at 3:07 pm #306389
    Martin
    Participant

    Re: Bosch Classixx Condensor Fault

    Also check that the TOC hasn’t tripped? That the carbons brush contact on the drum is good?

    It’s important to only test this type of m/c with a damp washload. A dry washload or no washload and it will do just as you have experienced anyway. 😉

    December 15, 2009 at 4:37 pm #306390
    cooky
    Participant

    Re: Bosch Classixx Condensor Fault

    Thanks for that lads………………. 😀

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.