- This topic has 5 replies, 4 voices, and was last updated 16 years, 3 months ago by
.
Viewing 6 posts - 1 through 6 (of 6 total)
-
Posts
-
This machine when started will not fill.It locks the door and runs the pump but does not progress to fill.Im thinking the board is at fault but also thinking it may have been caused by something else.If it is the module can someone provide the correct part no. please zwf14070w1 914226103(00)
Re: zanussi zwf 14070
Go to page 5 on here 9th post down and you will see i had one like this two weeks ago.
If you don’t have the service manual to access the fault codes,send me your email and i will forward you a copy. 😉
John.Re: zanussi zwf 14070
Damp can cause this – look for condensation on motor brush holders.
Also check filter/sump in case it’s blocked.
Mike.
Viewing 6 posts - 1 through 6 (of 6 total)
- You must be logged in to reply to this topic.