Smeg DWF1.1 continually cutting out

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Smeg DWF1.1 continually cutting out

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 15, 2009 at 1:40 pm #50970
    rawhead
    Participant

    Hi (again)
    More dishwasher woes 😥

    It is now continually cutting out through the course of a wash. On , off (two or three sec pause) and on again. This carries on for several hours. Every now and again it does not come back on and the cycle has to be restarted. No error codes.

    This model has the shiny paddles as controls so I cant do a reset (no buttons to push)

    Can anyone help please? 🙂 Thanks

    Jon

    December 16, 2009 at 12:53 am #306521
    Penguin45
    Participant

    Re: Smeg DWF1.1 continually cutting out

    SAME BASICS APPLY.

    Penguin45.

    December 16, 2009 at 1:28 pm #306522
    rawhead
    Participant

    Re: Smeg DWF1.1 continually cutting out

    Penguin45 wrote:SAME BASICS APPLY.

    Penguin45.

    Thanks Penguin 🙂

    I replaced the soap dispenser last year. That fixed the problem I was getting then.
    If I’m lucky its the Mains suppressor (If I can buy another one that is)
    If not its the board 😕

    Have since read a similar thread. “two short beeps followed by a brief burst of the pump, pause, then repeat” is exactly what I’m getting…

    Think I will also send my PCB to QER.

    If that doesn’t work a new dishwasher it will be! Not spending more than £200 this time!!!


    Thanks again.
    Jon.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.