- This topic has 3 replies, 2 voices, and was last updated 16 years, 4 months ago by
.
-
Posts
-
I previously resoldered the contact at the relay (part # js1-b-12v-f-h111) and it worked for about 2 months – but now I think the relay or the heater may be busted.
Any advice on an easy way to test the impedance of the heater – I assume that it is connected to the circuit board – so I should be able to masure it here, if I know which cables / terminals it is connected to.
Similarly – easy way to check the relay – other than taking it out and putting 12V across the coil?
Finally, do you keep these parts in stock?
Tanks and Merry Christmas….
Re: Zanussi DE6850 Machine not heating the water
Element should read c.25ohms. Best access it as there is no direct feed on one side.
Relay is not a spare part – pcb is. Relay could be sourced through Radio Spares, Maplins and the like.
Penguin45.
Re: Zanussi DE6850 Machine not heating the water
Do you have to access it from the back of the machine? Or where is the easiest way to access the heater?
- You must be logged in to reply to this topic.