creda s120br

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › creda s120br

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 23, 2009 at 5:26 pm #51157
    wards
    Participant

    main oven was failing to ignite(faulty door switch)replaced and all was fine,customer now has constant ignition when oven ignited,said it has been this way for some time but if he presses the clock button then it will stop,any thoughts appreciated 💡 ❓ 8)
    ps merry xmas to all

    December 23, 2009 at 8:47 pm #307091
    geoff1
    Participant

    Re: creda s120br

    Hi

    The most common reason for this to happen is that the tip of the electrode is not in the flame to allow it to earth. It can be either that the electrode requires a bit of adjustment or that this part of the burner is blocked so there is no flame. This fault many occurs when the flame dies down so remember to check it when the flame is at its lowest.

    Merry xmas

    Geoff

    December 23, 2009 at 10:31 pm #307092
    wards
    Participant

    Re: creda s120br

    geoff1 thanks for your response,this happens from initial start up,so maybe just an adjustment of the spark gap as when ignited it is on full gas rate. 8) thanks

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.