TCR13 drum shaft kit replacement

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › TCR13 drum shaft kit replacement

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • December 30, 2009 at 8:03 pm #51275
    PGS
    Participant

    Whats the procedure for replacing above. You cannot swing a cat in kitchen is it worth an uplift cheers Paul.

    December 30, 2009 at 8:06 pm #307446
    lerch
    Participant

    Re: TCR13 drum shaft kit replacement

    Not really only a normal hpt condensor dryer just take outside takes about 20 minutes.

    December 30, 2009 at 8:16 pm #307447
    PGS
    Participant

    Re: TCR13 drum shaft kit replacement

    I sit just a case of top,sides, and back to gain access or just back.

    December 30, 2009 at 9:16 pm #307448
    iadom
    Moderator

    Re: TCR13 drum shaft kit replacement

    Ideally you would remove the drum but I have managed to change the shaft by removing the top and releasing most of the screws down the sides of the back panel.

    There is just enough room to ease the back panel backwards to change the shaft. A few scratches are inevitable though.

    Jim.

    December 30, 2009 at 9:37 pm #307449
    PGS
    Participant

    Re: TCR13 drum shaft kit replacement

    Thanx Guys. All the best for 2010.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.