- This topic has 0 replies, 1 voice, and was last updated 16 years, 2 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Cust said The above D/W overfilled and leaked out the door,
Now when i run it, it seems to feel to the correct level but no circ pump movement, On closer inspection of the circ pump it does seem rather stiff & squeaky so i’m going to replace it.
Just wondering to any other ideas as to why this has happened?
(one other little piece of info, it does seem as though the board has previously been soldered for a heat fault – doubt this has any relevance but thought i’d say)
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.