- This topic has 5 replies, 3 voices, and was last updated 16 years, 2 months ago by
.
-
Posts
-
Water full indicator on and won’t go out, preventing dryer from working. No water in tank. Can you tell me where water sensor is or how to fix prob?
Cheers
theres a valve
if you pull out the water tank, youll see it at the backtheres the other valve, which is usually the case, which is located at the rear, its either gunged up or broken
Re: Hotpoint Condenser TDC60
both valves ok, but water light still on. where is the sensor for this?
Re: Hotpoint Condenser TDC60
Its a microswitch mounted on top of the float chamber. situated deep inside the machine.
Remove the mains plug and then remove the right hand (from front) side panel you will just about be able to see it behind the motor. It has three wires going to it.
Sometimes the switch can fail or stick, sometimes the float chamber becomes clogged up with gunge.
Access is very difficult whatever the problem.
The internal valve that you can see at the back of the water container housing is part of the float chamber as well.
- You must be logged in to reply to this topic.