Bosch WVT1260

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #52192
    PGS
    Participant

    Hi I replaced water valve to above in October and cleaned condenser at same time. Customer has been back on saying steam escaping from soap drawer again. Any more pointers appreciated. Cheers Paul.

    #310896
    electrofix
    Moderator

    Re: Bosch WVT1260

    to my knowledge you are not going to stop all steam escaping from any washer dryer
    am assuming its a cold kitchen so steam is more visable

    but if you look at the mechanics all are a closed circuit air goes round in a circle. if any escapes then more air has to go in otherwise you would get a vacuum. since i assume there is no way the air can get in other than the way it is getting out then then the drum is breathing

    i would talk to bosch customer services as if you are an owner see whet they say

    hope this helps

    Dave

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.