- This topic has 1 reply, 2 voices, and was last updated 16 years, 2 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
I have a customer who purchased a fhp motor from me for this machine. he phoned me today to say he has lost all the fixings for it. The bolts and washers are no problem but i need the rubber washer/grommet that fits on the lower fixed leg of the motor or can he get away with packing the overlap of the stud out with washers
Many Thanks
AndyRe: creda w100fw
Got one I just pulled off an old motor under the desk. It’s hard plastic, 2mm thick, (outside dia. 17mm) with 2mm thick flange at end. Should be OK to wrap some insulation tape round peg and maybe an inlet hose washer over it first, to substitute for the flange.
If not, pm me your address and I’ll send you this one, though it has a section broken away from the flange.
Mike.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.