hotpoint wf 100 F08 fault

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hotpoint wf 100 F08 fault

Viewing 10 posts - 1 through 10 (of 10 total)
  • Author
    Posts
  • February 4, 2010 at 2:04 pm #52222
    allan
    Participant

    hi all some help please.Hotpoint WF100 originally went to this machine which had all lights flashing after running for about 20 seconds on any program. sent board off to qer, came back no fault found, replaced board and now after running for about 20 seconds get the f08 fault, heater seems ok, could i have cocked the wiring up? all the edge connectors seem to only fit in one place, the only ones which are loose with no plug are the wires from the heater.
    Thanks Allan

    February 4, 2010 at 6:01 pm #310977
    iadom
    Moderator

    Re: hotpoint wf 100 F08 fault

    Sent you some info, personally don’t do F08 now, lifes too short. 😉

    Jim.

    February 4, 2010 at 8:27 pm #310978
    deltra
    Participant

    Re: hotpoint wf 100 F08 fault

    fo8 fault- heater relay ❗ sent board to emw (£46.88) machine now working great.

    February 4, 2010 at 8:43 pm #310979
    helo_75
    Participant

    for now….

    February 4, 2010 at 10:03 pm #310980
    allan
    Participant

    Re: hotpoint wf 100 F08 fault

    is it possible qer has overlooked something?

    February 4, 2010 at 11:14 pm #310981
    helo_75
    Participant

    no, itd more likely a duff pressure switch tbh

    February 5, 2010 at 12:49 am #310982
    deltra
    Participant

    Re: hotpoint wf 100 F08 fault

    🙂

    February 5, 2010 at 12:53 am #310983
    Penguin45
    Participant

    Re: hotpoint wf 100 F08 fault

    EMW actually test their boards on machine test rigs before sending them out. I have had 3 (?) problems in 16 years and they have all been sorted promptly.

    Keep it up, Tony.

    Chris.

    February 8, 2010 at 7:43 pm #310984
    allan
    Participant

    Re: hotpoint wf 100 F08 fault

    No tried new pressure switch, Checked every wire from start to finish and all connectors, spoke to qer reckons they test thoroughly and would not be the board……………but?

    February 9, 2010 at 12:57 am #310985
    Penguin45
    Participant

    Re: hotpoint wf 100 F08 fault

    They’ll be wrong, then. Send it to EMW…..

    Penguin45.

  • Author
    Posts
Viewing 10 posts - 1 through 10 (of 10 total)
  • You must be logged in to reply to this topic.