Zanussi Washer 90 minute wash in 5 minutes

This topic has 5 replies, 5 voices, and was last updated 16 years, 2 months ago by neilsukwg.

Viewing 6 posts - 1 through 6 (of 6 total)

Author

Posts
February 4, 2010 at 7:54 pm #52239

neilsukwg
Participant

Model ZWF1432
pnc/ele914521108/02

Can anyone help out with this machine which starts as normal but then goes to end suddenly.

Have run test programmes to verify machine is heating, checked all connections, pressure switch, carbons, ntc reads 7.5k ohms when cold, so I am suspecting a board fault?

(probably not relevant but found a supply 47v to the heater during the start of the wash cycle)

Neil

February 4, 2010 at 11:01 pm #311036

rocker
Participant

Re: Zanussi Washer 90 minute wash in 5 minutes

Check motor taco magnet (loose) worth a look. .hope this helps
john.

February 4, 2010 at 11:27 pm #311037

leavemetogetonwithit
Participant

Re: Zanussi Washer 90 minute wash in 5 minutes

If it’s got a recirculation pump, you may find that it is f….erm…not working.
If it’s burnt out, it might have taken the ACS108 a/c switch on the board with it. I put all this in a thread somewhere about last April.
Mike.
Ah, found it. http://www.ukwhitegoods.co.uk/modules.p … highlight=

February 4, 2010 at 11:46 pm #311038

neilsukwg
Participant

Re: Zanussi Washer 90 minute wash in 5 minutes

Don’t think this one has a recirc pump 😥 but enjoyed thread you linked to. Sad or what 🙁

February 17, 2010 at 7:29 pm #311039

bigchrisoioi
Participant

Re: Zanussi Washer 90 minute wash in 5 minutes

go into diagnostics to find fault code…..get number and i can advise

February 17, 2010 at 9:39 pm #311040

lasty
Participant

Re: Zanussi Washer 90 minute wash in 5 minutes

rocker wrote:Check motor taco magnet (loose) worth a look. .hope this helps
john.

Well worth checking out .

Did one at the weekend , same symtoms – tacho magnet had come loose .

Hope this helps …
Author

Posts

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.