Hotpoint WF 860 – wont finish – stops on 1 min to go

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WF 860 – wont finish – stops on 1 min to go

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • February 5, 2010 at 6:00 pm #52271
    lasty
    Participant

    Hotpoint WF 860 …
    Put it through a 60 degree quick wash , all seemed well until the final spin which never happened . display shows 1 min to go but the machine just carries on distributing and pumping out with about 10 secs between reverses . ( no water in machine) .
    Hav`nt had chance to run a test sequence or play around with it much but i`ll be on it again tomorrow so thought i`d ask .
    Any ideas ??

    Cheers – Chris.

    February 5, 2010 at 6:57 pm #311161
    timdowning
    Participant

    Re: Hotpoint WF 860 – wont finish – stops on 1 minuit to go

    Do a search on…..WF860 AND minute.

    February 5, 2010 at 7:17 pm #311162
    lasty
    Participant

    Re: Hotpoint WF 860 – wont finish – stops on 1 min to go

    Tried mate – 1200 possibles , tried other searches but all to no avail !
    Sure i`ve seen something but i don`t think the search facility on here is ………

    `selective` enough . 😈

    February 5, 2010 at 7:26 pm #311163
    Penguin45
    Participant

    Re: Hotpoint WF 860 – wont finish – stops on 1 min to go

    Used correctly, ‘Search’ brings up 5 results:

    THIS ONE is the most relevant.

    Chris.

    February 5, 2010 at 7:34 pm #311164
    timdowning
    Participant

    Re: Hotpoint WF 860 – wont finish – stops on 1 min to go

    Lasty you must type it with AND in the middle.

    WF860 minute………….gives 1209 results.

    WF860 AND minute……gives 5 results.

    February 5, 2010 at 7:36 pm #311165
    timdowning
    Participant

    Re: Hotpoint WF 860 – wont finish – stops on 1 min to go

    By the way, thanks for the capacitor fix to the hotpoint boards.

    Anymore up your sleeve???

    February 5, 2010 at 7:46 pm #311166
    lasty
    Participant

    Re: Hotpoint WF 860 – wont finish – stops on 1 min to go

    Thanks chris – helpful as usual 😆
    DOH 💡
    – (note to self) must get the hang of this search engine , thanks for the tip timdowning .

    Glad you found the cap fix useful – nothing new at the mo , spending time sorting out some blown WMA boards using a tip on the same sticky by DDSDDS – GREAT `sticky`…. 😆

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.