- This topic has 4 replies, 2 voices, and was last updated 16 years, 2 months ago by
.
-
Posts
-
cant find in known fault codes.
this m/c starts through 1st wash or rinse whatever selected, then goes through to drain at end then shuts down, bleeps, then the programme select light flashes, and the 1st light (rinse prog) light comes on. not flahing i.e. x no of times, on permenant. any help.
if you reset it goes through the same sequence again.
TELL..Re: w/pool d/washer mod ADG957
Contsant flashing and beeping is usually down to the ntc so i would try that first but its odd that it goes through to a drain then does it. Beko ntc pt no 1884400100 is cheaper alt to the whirlpool one and fits the same. If that doesn’t sort it then suspect a board fault.
Nige
Re: w/pool d/washer mod ADG957
set the m/c away on eco wash, it heated upto given temp then advanced through, would ntc cause this, after it heated ,it seemed to stick on the drain at end of first wash for a while then shut down, agaiin with with programme selector light flashing, and the it reselected back to rinse prog/light..itself.
TELL..Re: w/pool d/washer mod ADG957
It does sound more like pcb fault because it goes to the rinse but cheap enough to give thermistor a try as the only two faults i’ve come across with constant flashes and beeps have been one or the other. Sorry if thats a bit none specific though
Nige
- You must be logged in to reply to this topic.