Haier / Hec washers

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Haier / Hec washers

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • February 12, 2010 at 10:28 am #52442
    Steven
    Participant

    Hi

    Any one done a bearing change on one of these yet, if so whats involved?

    Steven

    February 12, 2010 at 1:24 pm #311802
    helo_75
    Participant

    a lot of graft

    everything off, tub out the top, split and just change bearings

    cheap parts too

    nearly everyone ive done, ive pushed the bearing into place with my thumb , theyre that bad 😐

    February 12, 2010 at 7:03 pm #311803
    Madmac
    Participant

    helo_75 wrote:

    nearly everyone ive done, ive pushed the bearing into place with my thumb , theyre that bad 😐

    That’ll be the Chinese version of the interference fit.. the non interference fit.. velly good. :rolls:

    February 12, 2010 at 7:37 pm #311804
    Turbo
    Participant

    Re: Haier / Hec washers

    The Chinese hate interference, you have been warned 😆

    Graham

    February 12, 2010 at 9:33 pm #311805
    lasty
    Participant

    Re: Haier / Hec washers

    Turbo wrote:The Chinese hate interference, you have been warned 😆

    Graham
    😆 😆 – nice one …

    regarding the fit – we LIGHTLY dimple the shaft with a centre punch .

    February 13, 2010 at 12:34 am #311806
    Penguin45
    Participant

    Re: Haier / Hec washers

    I lighty dose them in petrol and set them alight.

    Well, I wish..

    P45.

    February 13, 2010 at 7:50 am #311807
    expertcat
    Participant

    While on a haier course was told to order everything for the hec haus models as it’s easier to make up complete tub prior to visit I beleive the 1200 & 1400 spin machines are alot easier to do as you can take the fronts off but the hec is through the top

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.