bosch sgs43a32gb/01

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › bosch sgs43a32gb/01

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • February 24, 2010 at 12:08 pm #52753
    andysam
    Participant

    tried everytyhing but just fills and empties constantly but could it be the board? any help will do

    February 24, 2010 at 12:12 pm #312978
    adv
    Participant

    Re: bosch sgs43a32gb/01

    have you cleaned transfer tube left hand side an check fill matrix aint gunge up if has one 😆

    February 24, 2010 at 1:28 pm #312979
    Martin
    Participant

    Re: bosch sgs43a32gb/01

    andysam wrote:tried everytyhing but just fills and empties constantly but could it be the board? any help will do

    Water level on these is controlled by the magnet float in the tub. Sounds like it just needs taking out and cleaning?

    February 25, 2010 at 11:11 am #312980
    andysam
    Participant

    Re: bosch sgs43a32gb/01

    TRIED ALL THAT BUT STILL THE SAME PROBLEM, ANY OTHER IDEAS? CHEERS ANDY

    February 25, 2010 at 11:22 am #312981
    adv
    Participant

    Re: bosch sgs43a32gb/01

    on smegg dw and indesit washers fillin an emptyin at same time is pcb. so could be pcb.qer fixed a smegg board with that fault ask them if they fix them 😆

    February 25, 2010 at 12:16 pm #312982
    Martin
    Participant

    Re: bosch sgs43a32gb/01

    andysam wrote:TRIED ALL THAT BUT STILL THE SAME PROBLEM, ANY OTHER IDEAS? CHEERS ANDY

    If you are sure the float is clean and working OK (that it’s not put in upside down either?) then it will need the module (part No 489494) changing as well as the float (part No 489542) to cure the problem. 🙁

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.