wmd960

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › wmd960

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • March 5, 2010 at 10:15 am #52997
    DDSDDS
    Participant

    i have one of these machines in my workshop orignal fault water valve burst soaked the board new board from emw and away we go 4 or 5 washes machine is dead

    resistor r141 on board is blown so get a new one fit the resistor and all is well
    3 washes later exactly the same again
    anyone got any idea what is causing this
    i have checked motor and heater etc
    only clue is that before it went the fellah says it went clickity clickity
    now i dont know if that click was the door lock clicking about or the click of the resistor blowing
    any ideas would be a big help
    thanks in advance

    March 5, 2010 at 11:11 am #313952
    iadom
    Moderator

    Re: wmd960

    Will send you some tech info, might help to trace the circuits the resistor is involved with.

    Jim.

    March 5, 2010 at 3:46 pm #313953
    DDSDDS
    Participant

    Re: wmd960

    thanks iadom have had a look and at first glance it gives me a few clues but no smoking guns anymore help or someone that has run across the same problem would be great

    March 6, 2010 at 7:58 am #313954
    hebegebe
    Participant

    Re: wmd960

    Clickity clickity could maybe have been sparks (or a relay being switched). Could it be a wire shorting somewhere causing it? I often get the harness being chafed against the casing by an out of balance drum. It might explain the fault. Good luck. Graham

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.