Zan ZWF 12070W switched off on spin.. now DEAD!!!!!!!!!!

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zan ZWF 12070W switched off on spin.. now DEAD!!!!!!!!!!

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • March 10, 2010 at 7:13 pm #53140
    Madmac
    Participant

    Elderly owner switched the rotory sw to off during the spin (couldnt hear his telly apparently 🙂 ) ever since its been totally dead 😯
    Mains volts to plug into the PCB but not a light or sound from it whatever you try.
    EMW 1100 board on it, less than 2 yrs old. Any possible dodges to try afore i send it off to EMW??

    Thanks,
    Eddie.

    March 10, 2010 at 10:06 pm #314552
    aqualectric
    Participant

    Re: Zan ZWF 12070W switched off on spin.. now DEAD!!!!!!!!!!

    Definate PCB failure. 😉

    Steve.

    March 11, 2010 at 11:04 am #314553
    Madmac
    Participant

    Re: Zan ZWF 12070W switched off on spin.. now DEAD!!!!!!!!!!

    Yip, i’m with you there Steve 😉 Just thought it might be a component a determined tite wad like me could replace with a hammer & chisel. Trying to go easy on the poor old punters pension 8)

    Oh well, off to EMW then 🙂

    March 17, 2010 at 12:47 pm #314554
    Madmac
    Participant

    Re: Zan ZWF 12070W switched off on spin.. now DEAD!!!!!!!!!!

    Well, got this back from EMW today, not repairable.. chip damage.. so warn your ‘Lux owning customers NOT to switch their machines off during spin :rolls:
    So unless someone has a similar board they could sell me it looks like another Zan is for the crusher before the paint is dry 😥

    Anyone ❓

    Eddie.

    March 18, 2010 at 12:16 am #314555
    leavemetogetonwithit
    Participant

    Re: Zan ZWF 12070W switched off on spin.. now DEAD!!!!!!!!!!

    Madmac wrote: so warn your ‘Lux owning customers NOT to switch their machines off during spin

    Blimey, I think I’ve sometimes done that myself while testing. Must remember to press pause button first. Thanks for the warning.
    Mike.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.