Hoover washer/dryer mod HW120M

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hoover washer/dryer mod HW120M

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • March 11, 2010 at 8:50 am #53151
    Ashby
    Participant

    Rinsing problem.
    2 out of 3 it will rinse ok, on the 3rd rinse it just carries on filling whichever rinse cycle it’ts on?
    Many Thanks.
    Ashby

    March 11, 2010 at 9:12 am #314590
    Martin
    Participant

    Re: Hoover washer/dryer mod HW120M

    Faulty valve? Crudded up air chamber? Air hose punctured? Pressure S/w?

    March 11, 2010 at 10:14 am #314591
    Ashby
    Participant

    Re: Hoover washer/dryer mod HW120M

    Thanks Martin, tried pressure switch,and vessel they seem ok?
    Just strange it will only do it on the 3rd rinse? I put it on the rinse cycle several times and each time on the 3rd rinse it would just carry on filling?
    Ashby

    March 11, 2010 at 11:03 am #314592
    Martin
    Participant

    Re: Hoover washer/dryer mod HW120M

    Doesn’t make too much sense TBH…very odd???

    I’d take a careful inspection of the air hose just the same if I were you. 🙂

    March 11, 2010 at 8:14 pm #314593
    Ashby
    Participant

    Re: Hoover washer/dryer mod HW120M

    ok Martin. Will do. Many thanks for your help.
    Ashby

    March 13, 2010 at 1:31 am #314594
    leavemetogetonwithit
    Participant

    Re: Hoover washer/dryer mod HW120M

    Might be a bit late with this reply but don’t rule out the possibility of the valve intermittently sticking open. Try it on a flying lead to check.
    Mike.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.