ISE 5 Washer

Home › Forums › Manufacturer/WP/Insurer Specific Forums › ISE Trade Support Forum › ISE 5 Washer

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • March 15, 2010 at 6:18 pm #53249
    mike100
    Participant

    Washer bought july 08.
    Now not clicking in to spin.
    Checked load weights small and large still not spinning.
    Will spin without anything in it
    Could the module have gone?
    Mike

    March 15, 2010 at 6:37 pm #315072
    iadom
    Moderator

    Re: ISE 5 Washer

    CI555WH or ISE5-2 from Vestel?

    March 15, 2010 at 9:10 pm #315073
    boselecta
    Participant

    —-

    March 15, 2010 at 10:15 pm #315074
    iadom
    Moderator

    Re: ISE 5 Washer

    I am assuming it washes and tumbles correctly? The OOB can be a bit sensitive on these but not seen one that I couldn’t get to spin with a decent load. 😕

    March 15, 2010 at 11:01 pm #315075
    mike100
    Participant

    Re: ISE 5 Washer

    Yes, washes and tumbles ok but wont click in to spin
    Help, irate customer
    Mike

    March 15, 2010 at 11:43 pm #315076
    kwatt
    Keymaster

    Re: ISE 5 Washer

    If it spins empty then it points to OOB.

    Also check the belt is tight.

    I’ve not come across a module failure that would cause this sort of issue, it’s usually the loading that’s an issue.

    K.

    March 16, 2010 at 1:17 pm #315077
    mike100
    Participant

    Re: ISE 5 Washer

    Just to confirm this is ISE 5-2 Vestel 5.

    received job sheet confirming model.

    went back this am, checked belt for slack- ok it is a stretch belt anyway.

    Ran it again with no load – ok. as soon as loaded little or large you can see it struggling and it remains at 10 mins. on the spin cycle

    When the WMA Hotpoints did this EMW replacement module sorted it.

    Anyone had this same problem?

    Mike

    March 16, 2010 at 4:17 pm #315078
    iadom
    Moderator

    Re: ISE 5 Washer

    Not had anything like it, totally different type of motor/control to WMA’s this machine has 3 phase motor/inverter pcb.

    Can’t say I ever encountered such a fault on Hotpoint machines either and I have done the odd one over the years.

    Only had one motor/Pcb control fault on these and that was a faulty inverter board, but it did throw up an error message.

    A puzzler. 😕

    March 16, 2010 at 5:04 pm #315079
    kwatt
    Keymaster

    Mike, are you running this on the spin program?

    I’m just asking as the 5-2 only does a full spin on the cotton cycles and not at any other point. If memory serves it’s about 800 or so on the spin only cycle, drops to 600 on the delicates.

    K.

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.