Smeg DWD64 BL fault

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Smeg DWD64 BL fault

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • April 6, 2004 at 10:05 pm #5333
    admin
    Keymaster

    Hello,

    I have just refitted a Smeg DWD64 BL. When I try to run any programme, I can hear the pump running to pump away any remaining water but the machine won’t fill with water however long I leave it (the inlet hose is fitted and working correctly). Whilst the machine was out of action it was layed on its side during transportation – might this have caused water to get into the pressure switch?

    Any advice gratefully accepted.

    Mike

    April 7, 2004 at 7:19 am #110639
    admin
    Keymaster

    Re: Smeg DWD64 BL fault

    Sorry, should have said – this is a built in dishwasher.

    April 7, 2004 at 8:27 am #110640
    kwatt
    Keymaster

    Hi Mike,

    IT could be a valve fault, fill chamber or a couple of other things. To be honest if you’re not sure I’d advise an engineer for the appliance.

    Transporting the machine on its side shouldn’t have caused anything untoward to happen but, stranger things, as they say. 😉

    K.

    April 12, 2004 at 8:22 am #110641
    Oldtog
    Participant

    Re: Smeg DWD64 BL fault

    Hi Mike,

    Sounds like the base safety switch has been operated, the operation of this safety switch keeps the drain pump going all the time. You have to find out what has caused this switch to operate, it could even be broken and in a position of permanent operation.

    OT

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.