Dyson CR02 washing machine not draining – Dyson Virgin –

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Dyson CR02 washing machine not draining – Dyson Virgin –

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • March 18, 2010 at 8:42 pm #53350
    boselecta
    Participant

    never seen a Dyson washing machine before.

    The drain pump is blocked. It appears I have to take the front panel off to acess the pump.
    How do I take the front panel off. Got the facia panel off then got a bit worried with all that plastic and no obvious screws.

    Any advice?

    thanks

    March 18, 2010 at 9:53 pm #315498
    Madmac
    Participant

    Re: Dyson CR02 washing machine not draining – Dyson Virgin –

    Friggin NIGHTMARE to work on they are 👿 Ages since i did one but there is deeply recessed torx screws in door hinge to take out i think. If it has the pressure sw mounted on the facia, do remember to put the pipe on during rebuild.. i didnt 😳
    Can you not squeeze the pump off by going in through the back? Common 3 screw Askoll if i remember rightly.

    God was i glad when my customers one blew its PCB & she ditched it & bought a Bosch.

    March 18, 2010 at 9:53 pm #315499
    admin
    Keymaster

    Re: Dyson CR02 washing machine not draining – Dyson Virgin –

    hi

    have a look on the photo gallery on uk white goods there is one on there
    taken apart…?

    canufixit

    March 20, 2010 at 8:57 pm #315500
    boselecta
    Participant

    Thanks for the replies,
    once I got those deepset torx bits out of the door, which were a pain in the *rse, the rest wasnt too bad. (still took two calls and over an hour to replace the drain pump!)

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.